This is my first time setting up a Raspberry Pi4 (8GB). Before, I have used a RPi 3B for some other things. From what i have read is, that IO performance should be a lot better on the RPi4, as with the RPi3B. But i get the same speeds as before. I have setup the following:

  • Installed Raspbian Lite (64bit)
  • enabled SFTP/SSH
  • Setup a user for SFTP only access, with home on a connected USB HDD
  • the USB HDD is connected to one of the USB3 ports
  • This is the same setup on the RPi3B

When I now try to start to copy a 2GB file from my Laptop via LAN, i get in both cases a max of 11.6 or 11,5MB/s. But according to articles like this (https://www.jeffgeerling.com/blog/2021/raspberry-pi-25-gbps-16-tb-omv-nas-setup-and-performance), it should be much faster. Is there some secret, or whats the problem?

BTW: The Laptop runs on Manjaro Linux, where i start the transfer, there is no Windows available.

  • sudo_su@feddit.deOP
    2·
    1 year ago

    Its the cable. After changing the cable between the Switch and the Router, i got iperf test up to: 0.0000-10.0416 sec 1.09 GBytes 932 Mbits/sec.

    We had some workmen in the house a few weeks ago. Apparently, they damaged the cable. The test cable was unfortunately too short for permanent use, but it was enough for testing. I now get an upload of 65MB/sec on an average. This is about the same as the limit I had already determined through hdparm on the RPi4. I don’t know, why hdparm is faster directly on the laptop, maybe the USB Controller is not the best on the RPi4. But anything is better than 11MB/sec.

    The situation is different when the laptop is only connected to the network via WiFi. Here I get a maximum of 28MB/sec. I have not yet found a solution how this could be faster.