I have quite an extensive collection of media that my server makes available through different means (Jellyfin, NFS, mostly). One of my harddrives has some concerning smart values so I want to replace it. What are good harddrives to buy today? Are there any important tech specs to look out for? In the past I didn’t give this too much attention and it didn’t bite me, yet. But if I’m gonna buy a new drive now, I might as well…

I’m looking for something from 4TB upwards. I think I remember that drives with very high capacity are more likely to fail sooner - is that correct? How about different brands - do any have particularly good or bad reputation?

Thanks for any hints!

  • femtechEnglish
    7·
    2 months ago

    Yep, I have 6 14tb drives from them in raid10.

      • femtechEnglish
        6·
        2 months ago

        I just keep adding 2 more drives as it gets full. Not sure if that’s the best thing.

      • TheHolm@aussie.zoneEnglish
        51·
        2 months ago

        I would not trust these kind of dives in the mirror. IMHO RAID6 is the only way.

        • Avid Amoeba@lemmy.caEnglish
          2·
          2 months ago

          Due to risk of failure or risk of data corruption because the mirror can’t tell which drive is right when there’s a difference?

          • TheHolm@aussie.zoneEnglish
            2·
            2 months ago

            ZFS or BTRF mirror will know which side is at fault due to checksums. I’m more concern about simultaneous falures of two disks. Rebuilding of a RAID puts lots of pressure on remaining disks, so probability that remaining one dies too is much higher. with RAID6 3 disks need to die to lost date, which is less likely but not impossible.

          • turmacar@lemmy.worldEnglish
            2·
            2 months ago

            The second one.

            Mirroring is good for speed, but a storage mechanism with parity checks will always be more recoverable. And you will have far more storage available.

            • Avid Amoeba@lemmy.caEnglish
              1·
              2 months ago

              I think data checksums allow ZFS to tell which disk has the correct data when there’s a mismatch in a mirror, eliminating the need for 3-way mirror to deal with bit flips and such. A traditional mirror like mdraid would need 3 disks to do this.