depends on the solder, honestly. I doubt it would be an issue with consumer/mass produced electronics, but there’s a possibility. But if you’re doing your own with rosin-core solder (which is most solders,) the rosin/flux can. (you can remove it with stuff meant to remove it. which you should do because flux is freaking nasty.)
They make fume things that are basically a fan with a charcoal filter attached, if you want to buy it… they’re great, if you want to make it… “inspiration”
Honestly, short term, an old pc fan and acheap carbon filter duct taped to it will do it.
More optimally, a noctua high-static-pressure fan and a filter with a 3d printed housing/duct does the trick- the exhaust hose out a window is… overkill and “inconvenient” (unless you’re in a purpose built soldering station and can work it into a vent.)
Electronics release all sorts of non-cool chemicals… plastic related, and flame retardants.
That’s actually really funny.
This is not a helpful feature.
But where were the ants removed to?
That’s Lemmy.ml for you. Could swap to an instance like .world that doesn’t use the profanity removal feature.
Solder and flux, too.
Does solder actually emit fumes below melting point? I did not know about that.
depends on the solder, honestly. I doubt it would be an issue with consumer/mass produced electronics, but there’s a possibility. But if you’re doing your own with rosin-core solder (which is most solders,) the rosin/flux can. (you can remove it with stuff meant to remove it. which you should do because flux is freaking nasty.)
Oh, interesting. I did not know about that. Thanks for the info. I will be looking into some cleaning stuff for my personal soldering projects.
They make fume things that are basically a fan with a charcoal filter attached, if you want to buy it… they’re great, if you want to make it… “inspiration”
I’m planning on making one of those. With maybe a hose to it so I can point it out the window.
Thanks.
Honestly, short term, an old pc fan and acheap carbon filter duct taped to it will do it.
More optimally, a noctua high-static-pressure fan and a filter with a 3d printed housing/duct does the trick- the exhaust hose out a window is… overkill and “inconvenient” (unless you’re in a purpose built soldering station and can work it into a vent.)