Okay, it took a good amount of learning, but I’ve figured out how to get most of what I want with a custom keyboard build.
Here’s my goals:
- Ergonomic
- Quiet
- Dvorak
- But a normal person can still use it
- Cheapish because I’m a cheap bastard
With those in mind, here’s what I’ve finally settled on:
Board:
YMDK - Split 75% 84 Acrylic Kit
Keycaps:
YMDK - 9009 Retro 143 - Blank
Switches:
Haimu x Geon HG Red Silent Linear Switches A.K.A Haimu Heartbeat
See photos at the bottom of the post.
My plan is to take the switches to a fab-lab with a laser engraver and engrave the labels on the side of each keycap. Since the DSA profile is the same for every button, and I’ll have extras, I’ll have more than a few chances to get my laser settings correct.
By labeling the keycaps myself I can put the QWERTY label on the front side and the Dvorak label on the left or right side. By using this split design, I can combine the two halves to give people a totally regular looking keyboard that functions just as they expect.
Total cost including machine time: $182
What do you think? Do you think there’s room for improvement?
interesting idea of labeling them yourself. Good luck with that!
Other than that, seems reasonable.
Yeah, I’m very grateful that I’ll have plenty of spares. I think the biggest challenge is that I’m going to be engraving the sides. If it was the top it would be a lot easier, but God damn do side labeled keys look good.
I’ll have to create a rig of some kind that holds the piece in a secure and consistent location. Then I’ll probably index off of one of the lower corners so I get consistent placement of the etching. I’ll have to think more about how exactly I want to do it.
What I’d do is to take some clay or putty and press a key in the right orientation in there. Then stick the clay onto some holder.
That would work I guess.
That idea has sone advantages, but since I’ll be etching over 100 keycaps I’m going to see if I can come up with a more reusable rig. Right now I’m thinking to attach a switch to something else at the correct angle, so then I can just swap keycaps on the stem.
deleted by creator
There are specialty pcb clamps that could be useful to you for holding the keys in a constant angle/position for the labeling. Pcb clamps
I’ll look into it! That could be extra helpful given that it would be useful for soldering too.
I really like my ymdk and now have one for home and another for work. I think they are a solid choice
