Wow so shiny. Is that a 3D printed spacer? Did you put it in front of the glass lens?
Wow so shiny. Is that a 3D printed spacer? Did you put it in front of the glass lens?
Yes and no. While you can use the aux in all the strobes with the latest firmware, there are still only 2 brightness levels (a hardware limitation), and not all of them work like you would expect.
At the moment:
Yes I have installed the new multi-channel branch on all my TS10s. I suppose if you want to use the aux as a channel then you could prefer it to be brighter.
For myself, my aux leds are in high mode when in standby, and go to low mode when auto-lockout kicks in.
I use two pairs of vice grip pliers, one on the head and one on the bezel, with some leather to protect the finish. Heating the bezel up by dipping it in some freshly boiled water should make it easier.
Using this method I have removed many bezels (TS10/SP10 Pro/FW1A Pro) uneventfully. Removing the tail is another story though, because the leather just keeps slipping on the smooth parts of the tube/tail.
I am looking into sourcing some of these RGB leds to try, and discovered that there is an even smaller model available.
B36S3RGB is 0.69 x 0.69mm. These are the ones you are using.
While
B36L3RGB is 0.65 x 0.65mm. Have you thought about using these?
I have not studied the datasheets in detail but from a quick glance, apart from the size, they seem to be identical otherwise.
Awesome! Do you think if I can fit these RGB leds under an original FW1A reflector with the smaller opening (not the crappy FW1A Pro reflector)? If I can eventually find one that is.
Impressive!