I’m trying to print vase mode for the first time and I did get to print the first try, but this is happening on the bottom 4 layers. I have a 0.8 nozzle so the line width is set to 0.6 and the layer hight to 0.4. Even if I change my bottom thickness to 0.4 (1 layer) I still get this problem. Shouldn’t vase mode print without stops? I feel like I’m asking a very dumb questions but I’m missing sone importabt info here lol

  • kitnaht@lemmy.worldEnglish
    8·
    3 months ago

    This is normal for vase mode, unless you have the bottom disabled. You’re doing normal, full layers there probably. What does the print look like? Is this even so much of a blemish that you should bother?

    • MissJinx@lemmy.worldOPEnglish
      1·
      3 months ago

      I didn’t know. If I change to 1 layer it stillhas the same problem. For some reason I am not able to disable bottom

      • ShepherdPieEnglish
        1·
        3 months ago

        Does your model have a bottom or is it just a hollow cylinder that’s open on both ends?