Fourth try on a print. Tried to add some adhesive to the bed to get it to stick better. Watched the first two layers and went to bed. Woke up to a printer on strike.
Fourth try on a print. Tried to add some adhesive to the bed to get it to stick better. Watched the first two layers and went to bed. Woke up to a printer on strike.
That’s my exact setup and it’s great. I wouldn’t trade it for any other printer. It being enclosed is fantastic.
It very much is a printer you don’t need to pay attention to. Works as it should out of the box. Only thing you need to do is some maintenance. Cleaning, greasing some rods, etc… It doesn’t tell you when to do it like the X1C (from what I’ve heard) but greasing rods is like an every 3 months thing. All their maintenance on what and when to do it is on the Bambu website.
As it’s my first printer I’m not aware of any issues after a long hiatus. All I can say is that I often don’t print for a month or 2 and it prints just fine when I get back to it.
I’ve only ever had issues with the AMS where it would snap the filament but that has only ever happened when my filament was almost empty and thus very light. I should’ve either weighed it down or welded the leftover on another roll. Plus that doesn’t happen if you’re running out mid print. Only ever happened when I initiated a new print with the almost-empty roll.