You can order those directly from chip suppliers (mouser, digikey, arrow, etc.) for a lower cost than you could get them from framework. Also those are going to be very difficult to solder/desolder. You’re going to need a hot air station, and you need to pre-warm the board to manage the heat sink from the ground planes.
Not as impossible sounding. I mean I would never attempt it but you might be able to get away with it using a stencil, solder paste and one of those fancy toaster ovens with a broil setting. ROI would suck since you are probably gonna fail the first couple of times.
You can order those directly from chip suppliers (mouser, digikey, arrow, etc.) for a lower cost than you could get them from framework. Also those are going to be very difficult to solder/desolder. You’re going to need a hot air station, and you need to pre-warm the board to manage the heat sink from the ground planes.
Not as impossible sounding. I mean I would never attempt it but you might be able to get away with it using a stencil, solder paste and one of those fancy toaster ovens with a broil setting. ROI would suck since you are probably gonna fail the first couple of times.