Hey all, I just finished a run of Popandsicle’s excellent vase mode ornaments and I noticed these weird bulges happening all over the prints. The last run in a different color was flawless so I’m not sure where to start. I couldn’t find much on the issue with a bit of googling so I thought I’d check with you folks and see if you all had any insight.
I’ve calibrated my esteps and adjusted the resolution to be a bit easier on my printer (modified CR-10v2), and unfortunately my mainboard isn’t capable of linear advance.
Filament is overture royal gold, layer width is 0.6, height is 0.2.
I appreciate the help!
It’s definitely sagging, this happened as I was composing the OP:
That’s the worst I’ve seen, usually it’s like the original picture… Oh damn I just noticed it happens at the same layer heights every time.
Hmmm, so why would this filament give me trouble and not the other one? Or is this a z-axis issue or a slicer one?
I second callcc’s suggestions. I don’t think it’s a slicer or hardware issue, just optimizing your print parameters for the filament.