Hey all, I just finished a run of Popandsicle’s excellent vase mode ornaments and I noticed these weird bulges happening all over the prints. The last run in a different color was flawless so I’m not sure where to start. I couldn’t find much on the issue with a bit of googling so I thought I’d check with you folks and see if you all had any insight.
I’ve calibrated my esteps and adjusted the resolution to be a bit easier on my printer (modified CR-10v2), and unfortunately my mainboard isn’t capable of linear advance.
Filament is overture royal gold, layer width is 0.6, height is 0.2.
I appreciate the help!
Yeah, looking at the suggested print settings for vase mode makes me think I’ll need to mess with the temp and speed. I kept them mostly the same as my non vase mode profile which is probably is the issue.