My guy, robot mowers have been around for some time now. The catch is you need to bury a guide wire around the perimeter of the area the mower is meant to cut. Or at least that was the case the last time I looked into getting one.
There are some which are guided via gps now. However, i won’t trust them being so precise.
For me/us burying a guide wire was the better solution. Some manufacturers even claim, that you dont have to burry the line cos it will be overgrown by grass after a short amount of time.
GPS will only ever be accurate within 5 meters, which won’t cut it for small yards where even 1 meter over the line may send it down a hill or into the neighbors yard
Linus Tech Tips reviewed one that came with a little radio tower it used for position (guessing it used a combination of many sensors). Seemed to work OK in his flat little backyard.
My Roomba vacuums in a pattern. It finds the edges of the room, finds obstacles, and then goes ||||| across the middle of the room, doing little circles around table legs.
My robot mower does this. It traverses the lawn like a Roomba. Took me awhile to get used to.
Your WHAT?
My guy, robot mowers have been around for some time now. The catch is you need to bury a guide wire around the perimeter of the area the mower is meant to cut. Or at least that was the case the last time I looked into getting one.
There are some which are guided via gps now. However, i won’t trust them being so precise. For me/us burying a guide wire was the better solution. Some manufacturers even claim, that you dont have to burry the line cos it will be overgrown by grass after a short amount of time.
GPS will only ever be accurate within 5 meters, which won’t cut it for small yards where even 1 meter over the line may send it down a hill or into the neighbors yard
Linus Tech Tips reviewed one that came with a little radio tower it used for position (guessing it used a combination of many sensors). Seemed to work OK in his flat little backyard.
GPS gets down to 1cm or finer precision with an additional, stationary receiver, and time corrections. https://learn.sparkfun.com/tutorials/how-to-build-a-diy-gnss-reference-station
People have built DIY mowers utilizing tech like this. Problem is, the RTK receivers are far too expensive for all but the higher end mowers.
I love this reaction
My Roomba vacuums in a pattern. It finds the edges of the room, finds obstacles, and then goes ||||| across the middle of the room, doing little circles around table legs.
I’d need 6 of 'em for my lawn, last time I checked. Would bee nice tho
Must have a big yard! Mine is good for 1/2 acre but it could just run more often so I think you could stretch it a bit