Republicans on the House Small Business Committee pressed Energy Secretary Jennifer Granholm on Thursday for answers on proposed energy-efficiency standards for ceiling fans.

The proposed standards were first published in the Federal Register in June, and the comment period closed earlier this week. According to the Energy Department, the rule as applied to standard residential ceiling fans would cut fan-related electricity costs by about 40 percent relative to the least efficient fans currently available.

The House panel presented the rules as burdensome to ceiling fan manufacturers, particularly smaller ones.

“This proposed rule would decrease the maximum estimated energy consumption permissible for large diameter and belt driven ceiling fans,” committee Republicans wrote. “This rule would require numerous small business fan manufacturers to redesign their products and may put between 10 and 30 percent of small business ceiling fan manufacturers out of business. It appears that the Department of Energy may not have properly considered small entities during this rulemaking process.”

An Energy Department spokesperson told The Hill this aspect has been mischaracterized, saying in an email that the one-time total conversion cost would be about $107 million for all manufacturers.

“The incremental cost to consumers is $86.6 million annually, while the operating cost savings are $281 million annually — both at a 7 percent discount rate,” the spokesperson said. “The savings are more than triple the incremental costs.”

The spokesperson noted the standards, “which are required by Congress,” would not be in effect for five years and would save Americans “up to $369 million per year, while substantially reducing harmful air pollution — a crucial fact that some have conveniently failed to mention.”

Efficiency standards for home appliances have become culture war flashpoints under the Biden administration. The administration has restored a number of efficiency rules rolled back under the Trump administration, including for shower heads, water heaters and gas furnaces.

The most umbrage, however, has been reserved for efficiency regulations over gas stoves, beginning last year when Consumer Product Safety Commissioner Richard Trumka Jr. approved a request for information on hazards associated with the devices, which the CPSC formalized in March. Although Trumka has said there are no plans to ban gas stoves, House Republicans have introduced formal legislation this year to legally prevent such a ban.

  • FrickAndMortar@lemmy.ml
    link
    fedilink
    arrow-up
    43
    arrow-down
    1
    ·
    1 year ago

    They’ll clutch at anything they think they might be able to use to piss off their constituents, won’t they?

    “They’re coming for you gas stoves, citizen! Where will it end? What will you cook food for your family on?! Pic up a ‘don’t step on the gas’ ballcap for only $49.99, and go get ‘em!”

        • Fondots@lemmy.world
          link
          fedilink
          arrow-up
          9
          ·
          1 year ago

          I remember when some of the first LED bulbs hit the market, I replaced every bulb in my room (still living at home at my parents’ house) and never looked back.

          Back then it cost like $20 a bulb, didn’t care.

          The lights in my ceiling fan had a tendency to burn out frequently, never could identify a reason why after plenty of troubleshooting, but it incandescent bulbs did not like that fan.

          Pretty sure those same bulbs are still in there like 15 years later.

          Also my room was always the hottest in the house, and I was willing to try anything to shave off a couple of degrees. I never stuck a thermometer in there to measure it, so it could have been a placebo effect, but it certainly seemed like it maybe knocked a degree or two off the temperature to me.

          • fubo@lemmy.world
            link
            fedilink
            arrow-up
            4
            ·
            1 year ago

            LED bulbs were crap for the first couple years they were available. They were expensive and failed a lot. They’re much, much better today.

        • grue@lemmy.world
          link
          fedilink
          English
          arrow-up
          3
          ·
          1 year ago

          They’re still useful for things like older-model Easy-Bake Ovens and such.

          I remember either a joke (or possibly a real attempt) about re-branding them to “heat orbs” or something to get around the ban.

        • Espi@kbin.social
          link
          fedilink
          arrow-up
          1
          ·
          1 year ago

          They do get 100 CRI!

          Though if you want perfect color reproduction its much better to get actually professional equipment